Propex Malaga water heater details

Propex Malaga water heater details

Technical Data

Dimensions
Overall	H 250mm	W 325mm	D 445mm
Weight Empty			9.3kg
Tank Capacity			13 litres
Water Temperature Thermostat Setting			70 °C
Overheat Thermostat Setting			90 °C

Water Supply
The heater will operate satisfactorily on either a system where the pump is controlled by the tap microswitches or the one controlled by a pressure switch. It must not be connect to mains water supply. Water connections can be provided to suit a range of standard fittings. Reinforced or semi rigid pipe must be used.
Pressure Relief Valve Settings			3 bar
Maximum Working Pressure			2 bar
Maximum Working Supply Pressure			1.3 bar

Gas Supply
Heat Input		1.15kw	84g/h
Pressure Settings:		Propane	37mbar
		Butane	28mbar
		Mixtures	30mbar
Injector			Bray 960/40
Electrical Supply			12v DC
Gas Connection			8mm O.D.

Malaga E Only
Mains Electricity Supply		220/240vAC 50Hz Fused 5A

The Malaga and Malaga E heaters have been tested and comply with the following: 90/396/EEC gas appliance directive.

89/336/EEC EMC directive. 73/23EEC low voltage directive. It is manufactured under ISO 9001:2000 plus annex 11.3 gas directives 90/396EEC.

Installation Requirements

The heater should be floor mounted or suitably supported, normally in the bed box.

The flue is designed to pass through a vertical section of the caravan wall, structural sections of which should not be damaged.

The flue terminal position should not be closer than 300mm below an opening window or 600mm from a vertical corner.

Clearences required for installation and servicing: as seen from inside the caravan.

	LHS 240mm	RHS 5mm
	Rear 100mm	Top 5mm

Large 13 litre capacity - for longer washing and showering facilities

Efficient gas burner - for faster warm up

750W element on Malaga E - use on its own or with the gas burner for even faster hot water

Small flue terminal - neat appearance outside the caravan

Safe - combustion products are completely sealed from the caravan interior

Easy to fit and service - all controls accessible at the rear of the unit

Electronic control - turns on the heater at the flick of a switch and supervises burner operation

Automatic resettable overheat cut out

Compact dimension - more room to route pipework and ducting where necessary